The manufacturer was not notified. Any one know why it would be doing this? Yes, cars are very reliable these days, but when they break, all that sophisticated hoo-haa that makes them uber-reliable is expensive to fix. In some cases you need to pull over immediately to prevent damage while in others you merely need to tighten you gas cap next time you stop in order to reset the service engine soon light. If it's a misfire on a cylinder or two, check plugs and coil, also could be an injector. The failure mileage was 89,000.
The failure mileage was 98,000. If the part number is the same they will fit. Choose your vehicle by Make and Model and read articles our expert mechanics have answered. I tried to remove the key from the ignition but couldn't get it out. Everytime I start my car the svc light stays on all the time, my tires are always wobbly while slowing down and driving. It seems that the left front speaker is used for the transmitting of the warning sounds thus there is no sound from the left speaker.
The windows will become jammed and suddenly will not roll back up. It had to be towed back to our house. It sometimes will not activate the turn signals upon demand. Sep 17, 2011 Flashing service engine lights are very bad, means there is a problem that can potential cause harm to the engine. The car does have high miles but I have not had any problems till December of 2017 mileage is 203,602 all maintenance is performed under recommended mileage. The lever has to be pushed on or jiggled the then lights operate. The manufacturer was notified of the failure.
The vehicle made a jerking motion and stalled. The vehicle reduced speed and stalled several times. If it's a misfire on a cylinder or two, check plugs and coil, also could be an injector. It does not matter the speed that I am going. I slammed on the brakes and the engine shutoff. The dealer and manufacturer were not notified of the failure.
The easiest place to get warranty work like this is the dealership …and hopefully you have a good dealer. Thanks again for your answer. Per mechanic advice, I had a wheel bearing replaced. There is one thing you can try: tightening your gas cap. The contact owns a 2010 Chevrolet Cobalt.
I lose power steering when this happens and sometime vehicle wont start and my security light pops on. The contact stated that when the vehicle was started, the traction control and abs warning lights illuminated intermittently. I'm so glad I found this site!! I realize this is a 2010, but this has happened to my car since 2011. I will take it to C harper in belle vernon where I got it. The service engine indicator remained illuminated.
The failure mileage was 67,000. The manufacturer was not notified. But now I am having problems with the power steering. I don't think I will buy another Chevy when I see how many electrical problems are written online. So, there are literally hundreds of problems or issues that can cause that light to come on. I will do my best to get back to you as soon as possible. Try just using the key to unlock and start it.
They'll give you a print out that will give you a better idea on what's going on. The failure mileage was 92,000. At the last check the mechanic finally told me that there must be an electrical problem because he keeps getting the same code and they have replaced it too many times for it to still be the same problem. The contact stated that the new ground wire was added to connect to the trans control module, but the failures recurred after a few hours. Under the hood you'll find a 4 cylinder engine with more than 150 horsepower, providing a smooth and predictable driving experience.